Carl's Portrait Finished!!

Okay, this could be a mammoth post - the portrait is finished, and there's been a lot of work done since the last post... so, here goes...

With the main part of the face almost complete, I start work on the hair, the beard, and the helmet Carl is wearing as part of his re-enactment costume.

The hair is built up much in the same way as the mustache; deliberate pencil strokes put down in the direction of the strands of hair themselves. All the time I'm adding pencil marks, I bear in mind where the light is hitting the hair and make sure to lighten the pencil strokes in this area.

You'll also note I have a sheet of paper that lays on top of the drawing - this is to stop my hand smudging the pencil that's already down on the paper as I work on the other side of face. Carl's hair is dark, and as this part is on the opposite side to the intense sunlight, it will be the largest dark part of the image. To make sure I don't go too dark, I start work on the metal helmet he's wearing. By working round the whole image like this I can make sure that one part doesn't become too dominant in the balance between light and dark, thus keeping the focus on the main part of the face.

I mentioned in the last post about using a Q-tip or cotton swab for blending the pencil to create a softness, and I use this method quite heavily in the creation of the helmet. I need to ensure the helmet has a different textural look than to the face and hair. The metal, although dented and scuffed a little, is still smooth and somewhat reflective, so I carefully blend the pencil and add detail to create the smooth but worn look of the metal.

With the metal helmet pretty much done I go back to the hair. Finding the balance on both sides of the face is very important; by that I mean the overall composition of the portrait. The composition is the placing of the dark and light elements around the image. If one side of the drawing is too dark or too light that it makes your gaze go to just that part, then the drawing has failed. I need to make your eyes move fluidly around the drawing, seeing the focal point first and then comfortably moving around the detail, taking in the whole image, until you are drawn back to the focal point.

The left side of the drawing is pretty easy to work on; there's no direct sunlight on the hair, so I just need to capture the texture of the hair, but it's a totally different story on the other side of the face...

...the sun is highlighting the hairs on Carl's beard. There's two ways I can deal with this. One is to create the beard and then lift off the pencil marks to create the highlights with a putty rubber. But the detail is too small for the putty rubber and it lifts off too much of the surrounding pencil. The other way is to keep the paper white in the areas of the individual hairs. Again, the detail is small, so I carefully put down the marks for the beard whilst trying not to block out the white paper where I want the sunlit hairs to be. This takes time, patience and a very steady hand!

But bit by bit the beard is created, and after stepping back several times to take an appraisal of the drawing, I reach the point where the portrait is finished...

It's a successful portrait. It looks like him, I've illustrated the sunlight on his face, I've created realistic detail in the skin, hair and metal of the helmet, and I've retained the focal point whilst still creating areas of interest around the whole face and I don't think it needs anymore work. I think Carl will be happy with it too.

Carl's Portrait continued...

Only had an hour to play on the drawing board and even that had numerous interruptions from the phone! But here's the progress I made...

 

I'd finished working on the brow and forehead for the time being, and moved onto the bottom of the face. Carl has a very distinct smile, with a mustache and a beard so there's a lot to do here! As well as that, he's being lit by bright sunshine, so I have to pay close attention to texture, form and light.

I'm using a variety of pencil marks to create the smoothness of the skin and the roughness of the mustache. By gently laying down light, soft pencil marks and blending with the Q-tip I create the tones of the skin. The mustache is created by stronger, darker lines which are applied quite firmly in bold strokes, largely in the direction of the hairs which make up the overall mustache.

Trying to suggest the darkness of the mustache in very bright sunlight is a bit of a challenge and I do this by laying down the dark pencil lines and then using a putty rubber to lift of the majority of the pencil. It helps create some texture, a hint of what's there, but allows the lightness of the paper to show through, suggesting the sunlight. So far, so good but time's run out and I'll have to grab another hour tomorrow.

Carl's Portrait continued...

Work is just crazy busy at the moment so I was only able to grab a short while to sketch on Carl's portrait; here's where I left off from before...

The face is lit by bright sunlight, coming from the right hand side of the image, and I'm trying to keep that sense of warm sunlight flooding the face. So each stage of tonal build-up is carefully done, so as not to darken the whole portrait too much.

Using the mechanical pencil I very lightly start adding lines to build the form of the nose. To soften any lines that I don't want showing I use the end of a Q-tip or cotton swab, very gently rubbing the pencil to blend and soften the marks, but always being aware of where the darker build up of pencil is going; I don't want to distort the look of the nose. As I'm blending, if there's too much pencil on the Q-tip I just grab another one. There are different tools you can use for blending; I just find the cotton swabs easiest and they're cheap and plentiful.

When I've done some work on the nose I move back to the forehead.

Again, I'm laying down a subtle layer of pencil and blending using the cotton swab. Any excess pencil that builds up I carefully remove with a putty rubber, and then gently blend again. I move around the face this way, building tone and form a little at a time, so as not to overload any area of the portrait with too much dark pencil. I need to retain that feel of sunlight, so doing a little at a time works best for me.

That's all I've got time for, the sculpting is calling, so this'll have to wait again til tomorrow!

Carl's Portrait.

Started work on a portrait of Carl - a lovely guy who does re-enactment, and as it's such a big part of his life it seems only fitting his portrait should reflect his passion, so I'm sketching him in costume.

It starts with a rough outline to get the size of the head and the features in the right place.

With the outline done, as always, I start with the eyes. I'm drawing on a flat white cartridge paper, there's no texture to the paper, and I'm using a mechanical pencil with a HB lead.

The reference image I'm using for the portrait was taken in bright sunshine, and Carl's smiling, so the light and his facial expression makes his eyes seem smaller than if his face was relaxed and in softer light. This bright lighting is going to be a challenge!

Even with the eyes smaller I still need to capture the intensity in his facial expression, so I start right in the middle of the eye. The pupil is going to be the darkest part, but it needs a spot of reflection, a highlight, otherwise the eyes will look flat.

With the darkest part down, I start building up the tonal detail around the eye. The nose guard of the helmet is casting a shadow over the other eye, and blocking out any highlights within the iris and pupil, so this is going to be tricky not to make the eye look flat and lifeless.

I'm using the pencil to make soft cross-hatching marks that blend into each other and I'm building up layers of darker pencil to suggest the 3-dimensional form of the eyes. As I work, I sketch on both eyes, building up each a little at a time so that the tonal qualities work together.

The bright sunlight is on the right side of the face as we're looking at it, and at this stage I'm think of leaving the paper completely white to show the brightness.

So I'm just slowly mapping the tonal changes on the face as it transitions from shade to sunlight. I'm not worried about the range of tonal depth, just mapping the shapes out loosely.

I'm not decided yet, but I'm thinking of making the details around the edge of the face a little out of focus, or more sketchy, so there's more emphasis on the main part of the face.

But it's early days yet, I still have an enormous amount of work to do, and the feel of the portrait may change as work progresses. It's certainly going to be a challenge though!